Filter
Top Products
Schematic Capture - Basics
4-22 Electronics Workbench
Similarly, follow the steps in the example below to connect two components:
Tip Use the technique illustrated in the example above to automatically connect a
component to a junction.
4.5.2 Wiring Components Manually
To wire two components together, manually:
1. Click on a pin from the first component to start the connection (your pointer turns into a
crosshair ) and move the mouse. A wire appears, attached to your cursor.
2. Control the flow of the wire by clicking on points as you move the mouse. Each click
“fixes” the wire to that point. For example:
Step 1
Existing components.
Step 2
Move one component into contact
with the other and a junction is
automatically placed when the
mouse is released.
Drag the component
to a new location....
Step 3
Step 4
....and note that the two
components stay wired.
The mouse button was
clicked at these
locations.