Filter
Top Products
Variants
Multicap 9 User Guide 6-37
To remove components that are not in any of the variants:
1. Click on
Remove Components in the Variant Manager dialog box. The Components for
Delete
dialog box appears.
2. Click
OK to remove the components from the workspace.
6.5.2 Placing Parts in Variants
This section continues the example of the variants for the North American (NA) and
European (EU) markets used in “6.5.1 Setting Up Variants” on page 6-34.
To place a part in a circuit containing variants:
1. Place the parts in the usual manner, as documented in “4.4.1 Using the place component
browser” on page 4-4.
After wiring the parts in this example, the circuit appears as follows. Note that at this
point, each component is included in both the NA and EU variants of the circuit.
Note To display the variant status for the components, e.g., “In Variant (NA, EU)”, you must
enable the
Variant Data checkbox in the Circuit tab of the Sheet Properties dialog box.
If you do not wish to remove
any of these components,
click to remove the
corresponding checkmark
Indicates that this
component appears in
the NA and EU variants