Filter
Top Products
Labeling
Multicap 9 User Guide 4-35
4.9.2 Modifying Net Names
Multicap automatically assigns a net name to each node in the circuit. You can modify and
move these net names.
To modify a net name:
1. Double-click on the wire. The
Net dialog box appears:
2. Enter the desired settings.
3. To confirm your settings, click
OK. To cancel them, click Cancel.
Note You should exercise caution when changing net names, as they are critical to your
circuit’s connectivity as understood by PCB layout.
To lock a net name in position so that it will not move when the wire is moved:
1. Double-click on the net name. A dialog similar to the following appears.
2. Click
OK.
To unlock a net name that has been locked in position, double-click on the net name and click
OK when prompted.
Note You can also right-click on the net name and select lock/unlock.
Net name that appears on
the circuit window.