Filter
Top Products
Multicap Tutorial
2-6 Electronics Workbench
6. Place the parts in the Analog Amplifier section as shown below, rotating as needed.
After you place the AC voltage signal source, double-click on it. Change the
Voltage (Pk)
to 0.2 V and click
OK to close the dialog.
7. Place the parts in the Bypass Capacitors section as shown below.
8. Place the header and associated parts as shown below.
Once you have wired a circuit, you can drop two-pinned passive components like resistors
directly onto a wire. The connection is automatically made by Multicap.
Wiring the Circuit
Multicap is modeless; there are no wiring or part placement modes to toggle between. All
components have pins that you use to wire them to other components or instruments. As soon
as your cursor is over a pin, Multicap knows you want to wire and the pointer changes to a
crosshair.
J3 is in the Basic Group;
Connectors Family