Filter
Top Products
Schematic Capture - Basics
4-24 Electronics Workbench
If you attempt to connect a wire to a pin with an NC marker, the connection is prevented and a
message appears advising that you cannot connect to a pin marked as “no connection”.
To place an NC marker on a component’s pin:
1. Select
Tools/Toggle NC Marker. The cursor changes to a crosshair as shown below.
2. Click the crosshair on the desired pin to place the NC marker.
To exit the place NC marker mode:
1. Select
Tools/Toggle NC Marker.
Or
Press E
SC on your keyboard.
The crosshair on the cursor is replaced with a pointer.
Cursor
NC Marker