National Instruments 371889A-01 SONAR User Manual


 
Using the Pop-up Menus
Multicap 9 User Guide 3-13
3.3.2 Pop-up From a Selected Component
If you right-click on a selected element , a pop-up menu of appropriate commands appears.
These commands are:
Paste as Subcircuit Pastes the contents of the clipboard onto the workspace as a
subcircuit.
Replace by HB Replaces the elements that you have selected with a hierarchical
block. See 6.2.5.2 Replacing Components with an HB on page 6-9.
Replace by SC Replaces the elements that you have selected with a subcircuit. See
6.2 Hierarchical Design on page 6-3.
Font Displays a dialog box where you set font information for the circuit. For
details, see 3.4.2.4 Sheet Properties - Font Tab on page 3-28.
Properties Displays the Sheet Properties dialog box. Be sure that you have no
elements on the workspace selected, or the properties for that element
will appear instead. For details, see 3.4.2 Using the Sheet Properties
Dialog Box on page 3-23.
Command Description
Command Description
Cut Removes the selected components, circuits or
text, and places them on the clipboard.
Copy Copies the selected components, circuits or
text, and places them on the clipboard. For
details, see 4.4.6 Copying a Placed
Component on page 4-16.
Paste Places the contents of the clipboard to the
workspace. The cursor shows a ghosted
image of the item to be pasted. Click to indicate
where the item is to be pasted.
Delete Deletes the selection from the workspace.
Flip Horizontal Flips the selection horizontally. For details, see
4.7 Rotating/Flipping Placed Components on
page 4-30.
Flip Vertical Flips the selection vertically. For details, see
4.7 Rotating/Flipping Placed Components on
page 4-30.