Filter
Top Products
Multicap 9 Tutorial
Multicap 9 User Guide 2-7
You can wire the circuit that you placed on the workspace or you can use “Tut1.ms9” from the
Tutorial folder (found inside the Samples folder).
To wire the circuit:
1. Click on a pin on a component to start the connection (your pointer turns into a crosshair)
and move the mouse. A wire appears, attached to your cursor.
2. Click on a pin on the second component to finish the connection. Multicap automatically
places the wire, which conveniently snaps to an appropriate configuration, as shown
below. This feature saves a great deal of time when wiring large circuits.
3. You can also control the flow of the wire by clicking on points as you move the mouse.
Each click "fixes" the wire to that point.
4. Finish wiring the Digital Counter section as shown below.