Filter
Top Products
Schematic Capture - Basics
4-50 Electronics Workbench
3. Select
Insert/Date and Time to display the Date and Time dialog box.
4. Select the desired date/time format from the
Available Formats list and click OK to place
the selection.
4.10.1.5 Options Dialog Box
Use the Options dialog box to select the measurement units and text wrapping settings used in
the
Circuit Description Box.
To set the measurement units and text wrapping settings:
1. Open the
Edit Description window as described in “4.10 Circuit Description Box” on
page 4-47.
2. Select
Options/Rich Edit Options to display the Options dialog box and click the Options
tab.
3. In the
Measurement Units box, select one of Inches; Centimeters; Points; Picas.
4. Optionally, enable
Automatic Word Selection to select one word at a time when you drag
the cursor. If you wish to select one character at a time, clear this checkbox.
5. Click the
Rich Text tab and select one of:
•
No Wrap — typed text will be on one line until you press the ENTER key.
•
Wrap to Window — typed text will go to the next line when it reaches the edge of the
window.
•
Wrap to Ruler — typed text will go to the next line when it reaches the page margin.
6. Click
OK to close the dialog box.
4.10.1.6 Insert Object Dialog Box
Use the Insert Object dialog box to select an object, such as a bitmap or chart, to insert in the
Circuit Description Box.