Filter
Top Products
Manually Adding a Junction (Connector)
Multicap 9 User Guide 4-29
Note You should exercise caution when changing net names, as they are critical to your
circuit’s connectivity as understood by PCB layout.
4. Multicap prompts you to confirm that you want this duplication. Click
Ye s. Multicap
creates a virtual connection between the pins with the same net number.
4.6 Manually Adding a Junction (Connector)
Multicap automatically inserts junctions when you connect one wire to another wire to
differentiate them from wires that are crossing but not connected. You can also manually
place junctions on the workspace as desired.
To manually add a junction:
1. Choose
Place/Junction, or right-click on the workspace and select Place Schematic/Junction
from the pop-up. Your cursor changes to indicate that a junction is ready to be placed.
2. Click on the location where you want the junction placed. A junction appears at the
selected location.
Note You can place junctions on wires, on the workspace without them being attached to
any other circuit element, and directly on the end of component pins. If you place a
junction over two intersecting wires, they will be electrically connected.