Filter
Top Products
Multicap 9 Tutorial
Multicap 9 User Guide 2-5
4. Place the remaining components in the Digital Counter area as shown below.
While placing the 200-ohm resistor, rotate it to a vertical orientation by pressing C
TRL-R on
your keyboard.
Reference Designators (e.g., U1, U2) are assigned in the order the components are placed. If
you place components in a different order than in the original circuit, the numbering will
differ. This will not effect the operation of the circuit in any way.
5. Place the parts in the Counter Control section. After placement, right-click on each of the
SPDT switches and select
Flip Horizontal.
When a part is on the workspace and you want to place the same part again, highlight it and
select
Edit/Copy, then Edit/Paste.
The SPDT switches are in the
Basic Group; Switch Family