User Interface
3-22 Electronics Workbench
2. In the
Symbol Standard box:
• Select the symbol set to be used for components. The graphic changes to represent the
selected symbol set. To override this setting for individual components, see “8.5.2
Creating and Editing a Component’s Symbol with the Symbol Editor” on page 8-15.
3.4.1.4 Preferences - General Tab
In this tab, you set up selection rectangle behavior, mouse wheel behavior, bus wiring and
auto-wiring behavior.
1. In the
Selection Rectangle box, select either Intersecting or Fully Enclosed. See “ Setting
Dragging Selection Options” on page 4-14 for details.
2. In the
Mouse Wheel Behavior box select one of:
•
Zoom workspace — mouse wheel will let you zoom in and out on workspace.
•
Scroll workspace — mouse wheel will let you scroll up and down the page.
3. In the
Autowire box select the desired options to control the degree of automation used in
wiring. For details, see “4.5.6 Setting Wiring Preferences” on page 4-26.
For details, see “ Showing/
Hiding ‘Move’ Lines” on
page 4-16.
Enable if you wish to delete
wires that are connected to
components being deleted;
to delete wires that are
connected to components
being deleted, leave this box
unchecked.
