Filter
Top Products
Buses
Multicap 9 User Guide 6-21
8. In the
Bus box on the right, select the buslines on the main page to which you wish to map
the buslines that you selected above and click the down-arrow.
9. Click
OK. The connection from the bus in the main circuit is made to the Bus IO pin as
mapped above.
Note If you add more nets to the bus, you must double-click on the
Bus IO pin in the
sub-circuit or hierarchical block symbol and map the new nets via the
Bus HB/SC
Mapping Properties
dialog box.
6.4.2 Bus Properties
You can add, delete and rename buslines from the Bus Properties dialog box.
6.4.2.1 Adding buslines to a Bus
When you are in the Busline mode (see “6.4 Buses” on page 6-16) you can pre-enter buslines
for use when wiring to a bus.