Filter
Top Products
Schematic Capture - Basics
4-30 Electronics Workbench
To make a connection from a placed junction:
1. Move your cursor close to the junction, until the cursor changes to a crosshair ( ) symbol.
2. Click and drag a wire from the junction to the desired location and click to place.
4.7 Rotating/Flipping Placed Components
You can rotate or flip a placed component by either using the pop-up menu or selecting the
component and using commands from the
Edit menu. The instructions below describe the
pop-up menu method only, but the commands for rotating/flipping placed components that are
found in the
Edit menu are the same. See “A.1.2 Edit Menu” on page A-4 for details.
To rotate a component:
1. Right-click on the component.
Junction was automatically placed
when Ground was wired.
Junction placed directly on
workspace with no connections.
Junction placed over two
intersecting wires to form
electrical connection.
Junction placed on end of
component pin.