Garmin Flight Deck 100 Marine Instruments User Manual


  Open as PDF
of 688
 
190-00728-04 Rev. A
Embraer Prodigy
®
Flight Deck 100 Pilot’s Guide
151
AUDIO PANEL AND CNS
GTX 33/33D TRANSPONDER CONTROLS
Transponderfunctionisdisplayedon threelevelsofsoftkeysonthePFD:Top-level,ModeSelection,and
CodeSelection.Whenthetop-level
XPDR
Softkey is selected, the Mode Selection softkeys appear:
XPDR1,
XPDR2, STBY
,
ON
,
ALT
,
GND
,
VFR
,
CODE
,
IDENT
,
BACK
.
When the
CODE
Softkey is selected, the number softkeys appear:
0
,
1,
2
,
3
,
4
,
5
,
6
,
7
,
IDENT
,
BKSP,
BACK
. The digits
8
and
9
are not used for code entry. Selecting the numbered softkeys in sequence enters
thetranspondercode.Ifanerrorismade,selectingthe
BKSP
Softkey moves the code selection cursor to the
previous digit. Selecting the
BKSP
Softkeyagainmovesthecursortothenextpreviousdigit.
Selecting the
BACK
Softkey during code selection reverts to the Mode Selection Softkeys. Selecting the
BACK
Softkeyduringmodeselectionrevertstothetop-levelsoftkeys.
The code can also be entered with the FMSKnoboneitherPFD.Codeentrymustbecompletedwitheither
the softkeys or the FMS Knob, but not a combination of both.
Selecting the
IDENT
Softkey while in Mode or Code Selection initiates the ident function and reverts to the
top-levelsoftkeys.
After45secondsoftranspondercontrolinactivity,thesystemrevertsbacktothetop-levelsoftkeys.
Figure 4-34 Transponder Softkeys (PFD)
Selecting the BACK Softkey
returns to the top-level softkeys.
Selecting the BACK Softkey returns to the mode selection softkeys.
MSG
MSGBACKBKSP
IDENT
76543210
STBY ON
ALT VFR
CODE
IDENT BACK
XPDR
GND
IDENT
XPDR1
XPDR2
Selecting and activating Transponder 1 or Transponder 2:
1) Select the
XPDR
Softkey to display the Transponder Mode Selection Softkeys.
2) Select the
XPDR1
or
XPDR2
Softkey to select and activate the other transponder.
When turning on the system for use, the system defaults to the transponder active prior to shutdown. When
switchingbetweenTransponder1andTransponder2,thecodeandmoderemainthesame.Ifanewcodeis
entered in the active transponder, switching transponders does not bring back the previous code.
 previous next