Filter
Top Products
190-00728-04 Rev. A
Embraer Prodigy
®
Flight Deck 100 Pilot’s Guide
46
SYSTEM OVERVIEW
Exporting a profile to an SD card:
1) Insert the SD card for storing the Pilot Profile into the top card slot on the MFD.
2) Turn the FMS Knob to select the AUX - System Setup Page.
3) If necessary, activate the desired pilot profile to export. Only the currently active Pilot Profile can be exported.
4) Select the EXPORT Softkey. The system displays the Pilot Profile Exporting Window.
Or:
a) Press the MENU Key.
b) Turn the FMS Knob to highlight ‘Export Pilot Profile’ and press the ENT Key.
5) To export the pilot profile using the current supplied name, press the ENT Key with ‘EXPORT’ highlighted. To
change the profile file name turn the large FMS Knob to highlight the ‘SELECT FILE’ field, then enter the new
name with the large and small FMS Knobs, then press the ENT Key. Then press the ENT Key with ‘EXPORT’
highlighted.
6) If the profile name to be exported is the same as an existing profile file name on the SD card, the system displays
an ‘Overwrite existing file? OK or CANCEL’ prompt. Press the ENT Key to replace the profile on the SD card
with the profile to be exported, or turn the FMS Knob to highlight ‘CANCEL’ and press the ENT Key to return to
the Pilot Profile Exporting Window without exporting the profile.
7) If successful, the EXPORT RESULTS window displays ‘Pilot profile export succeeded.’ With ‘OK’ highlighted,
press the ENT or CLR Keys, or press the FMS Knob to return to the AUX - System Setup Page.
Pilot Profile Exporting Window, Enter a
Name to Use for Exported Profile
Export Successful
Figure 1-38 Pilot Profile Exporting Window (AUX - System Setup Page)
Date/time
The Date/Time Box on the System Setup Page displays the current date and time and allows the pilot to set
the time format (local 12-hr, local 24-hr, or UTC) and offset. The time offset is used to define current local
time. UTC (also called GMT or Zulu) date and time are calculated directly from the GPS satellites signals
and cannot be changed. When using a local time format, designate the offset by adding or subtracting the
desired number of hours.