Garmin Flight Deck 100 Marine Instruments User Manual


  Open as PDF
of 688
 
190-00728-04 Rev. A
Embraer Prodigy
®
Flight Deck 100 Pilot’s Guide
63
FLIGHT INSTRUMENTS
shows approximately what the indicated airspeed value will be in six seconds. If the trend vector crosses V
MO
/
M
MO
, the airspeed readout and the Mach readout change to yellow. If the trend vector crosses the red V
LSA
range,
the airspeed readout is displayed in yellow. The trend vector is absent if the speed remains constant or if any
data needed to calculate airspeed is not available due to a system failure.
TheAirspeedReferenceisdisplayedabovetheAirspeedIndicatorintheboxindicatedbyaselectionbug
symbol.Abugcorrespondingtothisspeedisshownonthetape.IftheAirspeedReferenceexceedstherange
shownonthetape,thebugappearsattheupperorloweredgeofthetape.SeetheAFCSSectionformore
informationabouttheAirspeedReference.
Vspeedscanbechangedandtheiragsturnedon/offfromtheTimer/ReferencesWindow.Whenactive(on),
the Vspeeds are displayed at their respective locations to the right of the airspeed scale.
Vspeed Flag
Takeoff
V
1
1
V
R
R
V
2
2
V
FS
FS
Landing
V
AP
AP
V
REF
RF
V
AC
AC
V
FS
FS
Table 2-1 Vspeed Flag Labels
Vspeedsarecategorizedaseithertakeofforlanding.TakeoffVspeedagsareautomaticallyturnedoffwhen
airspeedreaches160knots.Theorderinwhichthecategoriesaredisplayedisdeterminedbywhetherthe
aircraftisonthegroundorintheair.Iftheaircraftisontheground,thetakeoffVspeedsaredisplayedatthe
top of the Vspeed list. If the aircraft is in the air, the landing Vspeeds are displayed at the top.
Changing Vspeeds and turning flags on/off:
1) Press the
TMR/REF
Softkey.
2) Turn the
large FMS
Knob to highlight the desired Vspeed.
3) Use the small FMS Knob to change the Vspeed in 1-kt increments (when a speed has been changed from a
default value, an asterisk appears next to the speed).
4) Press the
ENT
Key or turn the large FMS Knob to highlight the ON/OFF field.
5) Turn the small FMS Knob clockwise to ON or counterclockwise to OFF.
6) To remove the window, press the
CLR
Key or press the
TMR/REF
Softkey.
 previous next