Filter
Top Products
190-00728-04 Rev. A
Embraer Prodigy
®
Flight Deck 100 Pilot’s Guide
373
HAZARD AVOIDANCE
sector scan
1) While in horizontal scan mode, select the BRG Softkey to display the Bearing Line and place the cursor in the
BEARING field. If the Bearing Line is not displayed, press the MENU Key and turn the large
FMS Knob to select
Show Bearing Line.
2) Press the ENT Key.
Figure 6-65 Selecting Sector Scan Position
3) Turn the small
FMS Knob to place the Bearing Line in the desired position. The location of the Bearing Line
becomes the center point of the Sector Scan.
4) Turn the large
FMS Knob to place the cursor in the SECTOR SCAN field.
5) Turn the small
FMS Knob to select FULL, 60˚, 40˚, or 20˚ scan.
6) If desired, readjust the Bearing Line as discussed previously to change the center of the Sector Scan.
7) Select the BRG Softkey again to remove the Bearing Line and cursor. The bearing reference is reset to 0º.