190-00728-04 Rev. A
Embraer Prodigy
®
Flight Deck 100 Pilot’s Guide
281
FLIGHT MANAGEMENT
MISSED APPROACH
Activating a missed approach in the active flight plan:
1) Press the PROC Key.
2) Turn the FMS Knob to highlight ‘ACTIVATE MISSED APPROACH’.
3) Press the ENT Key. The aircraft automatically sequences to the MAHP.
Or:
Press the Go-Around Button.
COURSE TO ALTITUDE
Inthismissedapproachprocedure,thealtitudeimmediatelyfollowingtheMAP(inthiscase‘6368ft’)is
not part of the published procedure. It is simply a Course to Altitude (CA) leg which guides the aircraft along
therunwaycenterlineuntilthealtituderequiredtosafelymaketherstturntowardtheMAHPisexceeded.
ThisaltitudeisprovidedbyJeppesen,andmaybebelow,equalto,orabovethepublishedminimumsfor
this approach. In this case, if the aircraft altitude is below the specified altitude (6,368 feet) after crossing
the MAP, a direct-to is established to provide a course on runway heading until an altitude of 6,368 feet is
reached. After reaching 6,368 feet, a direct-to is established to the published MAHP (in this case MOGAL).
If the aircraft altitude is above the specified altitude after crossing the MAP, a direct-to is established to the
published fix (MOGAL) to begin the missed approach procedure.
In some missed approach procedures this Course to Altitude leg may be part of the published procedure.
For example, a procedure may dictate a climb to 5,500 feet, then turn left and proceed to the Missed Approach
HoldPoint(MAHP).Inthiscase,thealtitudewouldappearinthelistofwaypointsas‘5500ft’.Again,ifthe
aircraft altitude is lower than the prescribed altitude, a direct-to is established on a Course to Altitude leg
when the missed approach procedure is activated.
Figure 5-98 Course to Altitude
Course to Alttitude Leg