Filter
Top Products
Vector Chart material · 117
Look charts around your own ship
You can use either TRUE MOTION or RELATIVE motion. Refer to DISPLAY MODE chapter. In True motion
your own ship moves until it reaches the true motion reset borderline. Then it will jump back to opposite position on
screen based on its course. In relative motion your own ship stays in a fixed position, while the chart under it moves
on screen.
If you use true motion and you press TM/CU RESET, your ship will immediately jump to true motion reset
position.
If you use true motion and you press SHIP OFF CENTER, your ship will go to that position on screen and continue
true motion movement from that position. When it reaches true motion reset borderline it will automatically jump to
true motion reset position.
If you use relative motion and you press TM/CU RESET, your ship will immediately jump to true motion reset
position and use that position as fixed position to stay on screen.
If you use relative motion, you can select a new fixed position to your ship by pressing SHIP OFF CENTER push
button.
Use ZOOM IN and ZOOM OUT push buttons to select desired scale of the chart display.
How to select a chart by its name on display
To select a specific S57 chart cell onto the display use Open menu command. Proceed as follows:
1. From Control Panel press Chart Plan pushbutton.
2. From menu check that there is a following text in first line: Activate ARCS
chart. If it is, then go to step 4.
3. If there is text Activate S57 chart choose this command.
4. Select Open command from the menu.
5. Choose desired chart from chart list dialog and press Open button.
6. When you select a chart it will be displayed automatically in the Electronic chart
area.