Filter
Top Products
Common Reference System · 325
Usage rights
Workstation can have different Usage rights. Master and Multi (Slave) rights allow control of both Planning &
Monitor modes and Navigation Sensors. Slave (Multi) and Plan usage rights allow only control Planning mode.
Workstations can be set so that
· One has Master Usage right. The rest has Slave (Multi) or Plan Usage rights.
· One or two has Multi (Slave) Usage right. The rest has Plan Usage rights.
How to set Usage rights as MASTER
One single Workstation can be selected to control Monitor modes and Navigation Sensors. This means that this
particular Workstation is used to select Route, User Chart, Reference Target and Pilot Data for Monitor modes.
To select configuration of System in which one selected Workstation has Usage rights set as Master, proceed as
follows:
1. Operate at Workstation for which you like to give Master Usage rights. Press INITIAL SETTING button, in
Workstation field select tick box Usage rights and select Master from the list box.
2. Indication MASTER is shown in lower right hand corner of display on selected workstation.
3. Indication SLAVE is shown in lower right hand corner of display on other workstations. Note indication
SLAVE is used, if the requested Usage right is MULTI, but another Workstation has been selected as
MASTER.
How to set Usage rights as MULTI or SLAVE
Multiple Workstations can be selected to control Monitor modes and Navigation Sensors. This means that these
particular Workstations are used to select Route, User Chart, Reference Target and Pilot Data for Monitor modes.
However the multiple control requires that none of the other Workstations is set for MASTER Usage rights. If any
other Workstation is set for Master Usage right then this workstation can be set only as SLAVE or PLAN. The
transition from SLAVE to MULTI Usage right is automatic. If later the Usage right selections in other
Workstations are changed, then the Usage right in this Workstation is automatically set as MULTI or SLAVE based
on non-existence or existence of a Master Usage right Workstation.
To select configuration of System in which multiple Workstations have Usage rights set as MULTI, proceed as
follows:
1. Operate at Workstation for which you like to give MULTI or SLAVE Usage rights. Press INITIAL SETTING
button, in Workstation field select tick box Usage rights and select either Multi (Slave) or Slave (Multi) from
the list box. First alternative indicates the selection and second alternative in parenthesis indicates the