Filter
Top Products
6 · Changes since release 03.01
Route Monitoring
· It is now impossible to select a Planned Route as Monitored Route, if it contains geometry check errors (for
example waypoints are too close to each other etc.)
· Waypoint names are displayed together with waypoint number (before only number)
· List of waypoints is also available as narrow window on information area
· changed terminology for WP information
· Next WP changed to To WP
· Time changed to ETA
Route Planning
· Optional Voyage Optimization System (VOS) has not been available since 01.01.2000.
Alarms in general
· If an alarm is based on a state - for example missing sensor signal - then a silent pending alarm stay after
acknowledge of the alarm until the state changes.
· New relay output from B-Adapter for IEC 62065 Track Control standard related alarms. This relay open if any
of related alarms is unacknowledged for 30 seconds.
Operation mode of ECDIS
· A new mode for ECDIS has been added, which is called "Standby". Standby mode is intended for staying in a
harbour, when you need to switch off audible alarms from the ECDIS.
Chart related changes
ARCS charts
· A history log has been added to record load and update of charts
S57 charts
· SENC conversion speed has been improved in general. Also the SENC converter can perform multiple updates
in one sequence without writing the intermediate results into Harddisk. This further speed up SENC conversion
for large amount of updates.