Filter
Top Products
Route monitoring · 255
How to select To waypoint
When you have selected a route to be monitored the system selects next waypoint automatically. Check that To
waypoint is desired one. The ECDIS will automatically advance to Next waypoint when you pass the To waypoint.
The ECDIS automatically set last waypoint of your monitored route as Final waypoint.
To select To waypoint, proceed as follows:
1. Press Route monitor push button to get Route monitor window.
2. Move cursor over the To WP box and press Select push button. Now you get a numeric keypad to enter the
number of the To waypoint.
3. Define a suitable waypoint and press OK.
How to select Final waypoint
Normally you use as Final waypoint the last waypoint of your monitored route and the ECDIS automatically did this
selection when you selected the monitored route. However sometime you may prefer to use as Final waypoint some
other waypoint than the last waypoint of the monitored route.
To select final waypoint, proceed as follows:
1. Press Route monitor push button to get Route monitor window.
2. Move cursor over the Final WP box and press Select push button. Now you get a numeric keypad to enter the
number of the Final waypoint.
3. Define a suitable waypoint and press OK.
How to view waypoint information
If you open Waypoints page on Route Monitor window,
you can view listed waypoint information. This
information is printed from route planning information
made for this voyage.
"TO WP" and "NEXT WP" are indicated on this list.