Filter
Top Products
Alarms · 423
Alarm number 3000: PARAM CHANGE DISABLED /3
------------------------------------
INSTALLATION PARAMETERS CAN BE
CHANGED ONLY IF THE ROUTE STEERING
IS NOT ON AND THE KALMAN FILTER IS
NOT USED.
CHECK THE SITUATION AND TRY AGAIN.
Alarm number 3300: SENSOR DATAFLOW ERROR /1
-----------------------------------
ECDIS HAS INTERNAL SENSOR MANAGEMENT
ERROR ALL CONNECTION TO SENSOR DATA
IS LOST
Alarm number 3500: AIS TARGET OVERFLOW /2/9
------------------------------------
WARNS THAT MAXIMUM COUNT OF AIS
TARGETS SET TO BE DISPLAYED ON ECDIS
HAS BEEN EXCEEDED WITHIN DEFINED
MAXIMUM RANGE. IT IS POSSIBLE THAT
SOME OF AIS TARGETS ARE NOT
DISPLAYED ON ECDIS. TO GET ALL AIS
TARGETS TO BE DISPLAYED, INCREASE
MAXIMUM COUNT OF AIS TARGETS OR
DECREASE VALUE OF MAXIMUM RANGE.
Alarm number 3501: AIS TARGET STORAGE FULL /2/9
------------------------------------
WARNS THAT MAXIMUM COUNT OF AIS
TARGETS WHICH CAN BE STORED FOR
DISPLAYING ON ECDIS HAS BEEN
EXCEEDED. IT IS POSSIBLE THAT SOME
OF AIS TARGETS ARE NOT DISPLAYED ON
ECDIS.
Alarm number 3502: DANGEROUS AIS TARGET /3/10
------------------------------------
WARNS THAT AIS TARGET HAS MET
DANGEROUS TARGET LIMIT SET BY CPA
AND TCA
Alarm number 3503: LOST AIS TARGET /3
------------------------------------
NO UPDATE INFORMATION RECEIVED FROM
TRACKED AIS TARGET WITHIN DEFINED
REPORTING INTERVAL OF VESSEL TYPE
Alarm number 4000: NO SENSOR PARAMETERS /2
------------------------------------
SENSOR PARAMETER FILES ARE MISSING.
LOAD INSTALLATION PARAMETERS OF
ECDIS. IF REQUIRED USE BACKUP COPY
OF PARAMETERS.
Alarm number 4001: B-ADAPTER ERROR /4/11
------------------------------------
B-ADAPTER DOES NOT OPERATE DUE TO A
SYSTEM FAULT. SWITCH OFF MAIN
CIRCUIT BREAKER AND THEN ON AGAIN.
CALL SERVICE IF FAILURE STILL EXISTS
Alarm number 4002: ENGINE CONTROL COMM ERROR /6/13
------------------------------------
CONNECTION TO ENGINE CONTROL HAS
BEEN LOST. CHECK THAT CONNECTION IS
OK.