Filter
Top Products
Changes since release 03.01 · 5
Changes since release 03.01
Overall operation related changes
Presentation of Position (Numerical presentation, where available)
· minute marks added for Latitude and Longitude values.
Information of Route Monitoring on ECDIS (available on Upper Information Area)
· changed terminology for WP information
· Plan CTS changed to Plan
· Next WP changed to To WP
· Next CTS changed to Next
· ETA changed to Time
· changed terminology for indication of "Goto WP" or "Goto Track" steering modes
· Plan
· Next
Information of Route Monitoring on Conning display
· changed terminology for WP information
· Next WP changed to To WP
· ETA changed to Time
· Indication in red text (corr) is available for following planned course, if the value is gyro error
compensated:
· Next
Position sensor related alarms
· Scattered SOG and/or COG from sensors causes a new alarm "2013 SOG&COG unreliable"
· If alarm 2013 is active, the system does not use dynamic WP for turns in "Goto WP" steering mode
· Alarm "2007 Position Discrepancy" is activated if set limit is exceeded between "Primary" and any
"Secondary" position sources or set limit is exceeded between own ship position and any position sensor. If
Kalman filter is in "ON" position the sensor who caused alarm 2007 is excluded from position calculation of
Kalman filter.
Position sensor related indications
· Together with alarm "2007 Position Discrepancy" a textual indication "Discrepancy" is shown for position
sensor in Pos page of Sensor.
· If position sensor has been excluded from position calculation by Kalman filter, a textual indication "Excluded"
is shown for position sensor in Pos page of Sensor.
New indication window for pending state and progress of Harmonization of Multi workstations operation mode
· Permanently shown with smaller window when harmonization is in pending state or in progress
· Details of harmonization in progress can be viewed or hidden on display