Filter
Top Products
Control Panel · 37
ZOOM IN
This is used to change the scale of chart display. The scales of chart have defined by system.
Pushing once the zoom in pushbutton user gets next greater scale of chart on display (e.g.
before ZOOM IN scale was 1:20000 and after ZOOM IN it is 1:10000). The scale of chart is
indicated as fraction in lower statusbar.
SET CHART CENTER
User can set the current cursor position as new chart center position by pushing SET CHART
CENTER button. Automatic true motion reset is disabled, when user presses SET CHART
CENTER button. This can be used to view ahead, route planning etc.
SHIP OFF CENTER
User can set the current cursor position as new position of ship on the display. This enables
automatic true motion reset. If the cursor position was in true motion reset area then an
automatic true motion reset happens.
TM/CU RESET
Pressing this button performs true motion reset and enables automatic true motion resets.
LOGBOOK M.O.B.
This button is used to record a predefined Man Over Board event to logbook. Position of this
event is also displayed on chart as a red mark.
LOGBOOK EVENT
This button is used to record an event to logbook. You can also write a comment for this event.
Note, it is displayed only if Events is selected to display in Chart display dialog box.
ALARM ACK
Alarm is displayed in the lower status bar. Also a red lamp is activated for this pushbutton.
High priority alarm has also an audible sound.
lamp SYSTEM FAILURE
This lamp is lit in case of internal failure which has serious effects for operation.