Filter
Top Products
402 · Parameters setup
Optimization parameters setting
The optimization parameters are used in optimization calculation. Therefore it must be defined these parameters
before calculation.
In order to get modify Optimization parameters, proceed as follows:
1. From Control Panel press INITIAL SETTING
2. From menu select Optimization parameters
3. Modify Optimization parameters by moving cursor to desired edit box and pressing select. This allows user to
modify value.
Note: HFO: Heavy fuel oil
DO: Diesel oil
This is very important data table, which contains ship's fuel consumption with the different speeds. There are 11
different speeds used to indicate fuel consumption on that specific speed. Prior to entering data to the form prepare
following graphic in order to find those 11 points.
Set 11 points on the graphics as explained above. Transfer those 11 points to the table. Use more points where the
curve bends more.
Example: 3,5 KN = 0,72 Ton / Hour HFO
Use the second graphic for Diesel Oil, if the Diesel Oil consumption is relative to the speed.