Filter
Top Products
Conning Display · 407
Conning Display
System Configuration
The ECDIS is able to receive information from various sensors. The ECDIS can adopt information either in analogic
or in serial data format which is sent by the sensors, makes navigation calculation from received data and shows this
information on Conning Display (Conning Display is an optional device).
The ECDIS can be connected to up to eight sensor which send analogic data and up to eight sensors which send
serial data.
Information displayed on Conning display is depending on selections in ECDIS and setup in Installation Parameters
of ECDIS where you can define layout of displayed information in Conning Display.
There are six predefined places to locate desired windows to conning display. The centre of display is fixed to show
information defined by the manufacturer, but both sides of display you can select freely displayed windows. (For
more information to select displayed windows, see Chapter "Installation Parameters" in Technical manual of ECDIS
EC 1000.)
There is a figure below to show locations of user defined windows. The content of windows are defined in
Installation Parameters of ECDIS.