Filter
Top Products
Step 10. When menu C15 (left) appears, move cursor to one of
the two available choices and press the Enter key.
These choices are described below.
a.
USE INSTALLED WAVEGUIDE KIT: Se
-
lecting this choice uses the values shown in blue
for IDENTIFIER, CUTOFF FREQ, SHORT 1,
and SHORT 2. Select this choice, for this exam
-
ple.
b.
USER DEFINED: Selecting this choice brings
up menu C15A (below), which lets you specify
waveguide parameters. After defining your
waveguide parameters, you are returned to
menu C3B.
Step 11. Continue the calibration sequence by following the
prompts as they appear. Connect the appropriate Iso
-
lation Devices, Broadband Loads, Shorts, and
Throughlines, when requested in the calibration se
-
quence.
37xxxE OM 7-31
MEASUREMENT CALIBRATION OFFSET-SHORT CALIBRATION (SSLT)
MENU C15
SELECT
WAVEGUIDE
KIT TO USE
–INSTALLED KIT—
IDENTIFIER
XXXX
CUTOFF FREQ:
XXX.XXXXXXXXX GHz
SHORT 1
XX.XXXX mm
SHORT 2
XX.XXXX mm
USE INSTALLED
WAVEGUIDE KIT
USER DEFINED
PRESS <ENTER>
TO SELECT
MENU C15A
ENTER
WAVEGUIDE
PARAMETERS
WAVEGUIDE
CUTOFF FREQ:
XXX.XXXXXXXXX GHz
OFFSET LENGTH
OF SHORT 1
XX.XXXX mm
OFFSET LENGTH
OF SHORT 2
XX.XXXX mm
PRESS <ENTER>
WHEN COMPLETE