Filter
Top Products
A-242 37xxxE OM
T ALPHABETICAL LISTING
MENU DESCRIPTION GPIB COMMAND
SET D.C. TERM FOR
LOWPASS PROCESSING
Since it is impossible to measure the true D.C. term
required for lowpass processing, a value must be
estimated. This menu allows a choice between five different
selections for this value.
None
AUTO
EXTRAPOLATE
Sets the D.C. term to a value determined by extrapolating
the data points near the zero frequency.
DCA; DCX?
LINE
IMPEDANCE
Sets the D.C. term to the characteristic impedance of the
transmission medium (Z
0
).
DCZ
OPEN Sets the D.C. term to correspond to an open circuit. DCO
SHORT Sets the D.C. term to correspond to a short circuit. DCS
OTHER
XXX.XXX
(REFLECTION
COEFFICIENT
X.XXX pU)
Sets the D.C. term to the value entered. DCV; DCV?
DCX?
PREVIOUS MENU Returns you to the previous menu. None
PRESS <ENTER>
TO SELECT
Pressing the Enter key implements your menu selection. None
Menu TD6, Set D.C. Term for Low Pass Processing