Filter
Top Products
A-166 37xxxE OM
M ALPHABETICAL LISTING
MENU DESCRIPTION GPIB COMMAND
MERGE CAL FILES None
CAL FILES MUST
EXIST IN THE
CURRENT DIRECTORY
None
MERGE CAL FILES Calls menu MRG2, then menu MRG3 to select the
calibration files.
LDMCF, IMCF
PRESS <ENTER>
TO SELECT
Pressing the Enter key implements your menu selection. None
Menu MRG1, Merge Calibration Menu
- MERGE CALIBRATION FILES -
RF CALIBRATIONS USING DIFFERENT METHODS AND AT
DIFFERENT FREQUENCIES CAN BE MERGED USING CAL FILES.
- REQUIREMENTS -
- PERFORM TWO RF CALIBRATIONS USING THE SAME CAL TYPE
AND STORE EACH CAL AND FRONT PANEL SETUP TO DISK
(e.g. CALFILE1.CAL AND CALFILE2.CAL).
- CAL FIES MUST BE PLACED IN THE CURRENT DIRECTORY
OF THE SD CARD OR USB DRIVE.
- THE COMBINED FREQ LIST CANNOT EXCEED 1601 POINTS.
- INSTRUCTIONS -
1. SELECT <MERGE CAL FILES> TO READ THE FIRST AND
SECOND CAL FILES FROM DISK (E.G. CALFILE1.CAL AND
CALFILE2.CAL, REPECTIVELY).
2. THE FREQUENCY LISTS AND MATCHING CORRECTIONTERMS
ARE COMBINED. FOR FREQUENCIES WHICH COINCIDE,
THE TERMS FROM THE FIRST CAL FILE ARE USED. THE
FRONT PANEL SETUP FROM THE FIRST CAL FILE IS USED,
EXCEPT THAT THE START AND STOP FREQS ARE ADJUSTED
TO INCLUDETHE ENTIRE RANGE. THE DATA POINT TYPE
IS CHANGED TO MATCH THE RESULTING FREQUENCY LIST
(I.E. NORMAL, N-DISCRETE, TIME DOMAIN HARMINIC).
IF DESIRED, SAVE RESULTS.
Menu EXT_MRG1, Merge Calibration Menu