Filter
Top Products
10-8 PIN DEPTH
SPECIFICATIONS
The depth of the center pin on connectors is a critical specification,
which if not met, can cause damage to mating connectors. Table 10-1
provides pin depth examples and Table 10-2 provides pin-depth speci
-
fications for associated AutoCal connectors.
37xxxE OM 10-13
AUTOCAL PIN DEPTH SPECIFICATIONS
Example 1:
FEMALE MASTER GAUGE BLOCK (protrusion)
Desired nominal value: 0.2070
Case1 Actual value of master gauge 0.2071 (protrusions 0.0001 more than desired)
Gauge should be set to indicate: +0.0001
Case2 Actual value of master gauge 0.2069 (protrusions 0.0001 less than desired)
Gauge should be set to indicate: -0.0001
Example 2:
MALE MASTER GAUGE BLOCK (cavity)
Desired nominal value: 0.2070
Case1 Actual value of master gauge 0.2071 (cavity 0.0001 deeper than desired)
Gauge should be set to indicate: -0.0001
Case2 Actual value of master gauge 0.2069 (cavity 0.0001 shallower than desired)
Gauge should be set to indicate: +0.0001
Table 10-1. Checking Connector Pin Depth (Example)
Device Connector Pin Depth (inches)
3658XXX K-Female +0.0000 to -0.005
3658XXX K-Male +0.0000 to -0.005
3658XXX N-Female *[0.207](+0.000, -0.005)
3658XXX K-Female *[0.207](+0.000, -0.005)
32K50
32KF50
K-Male (cable side) **Negative Indication
K-Female +0.0000 to -0.0005
K-Male (DUT side) +0.0000 to -0.0005
32L50
32LF50
K-Male (cable side) **Negative Indication
3.5mm-Female (DUT side) +0.006 to -0.008
3.5mm-Male (DUT side) +0.006 to -0.008
32S50
32SF50
K-Male (cable side) **Negative Indication
SMA-Female (DUT side) +0.0005 to -0.0015
SMA-Male (DUT side) +0.0005 to -0.0015
*Gauging Type N Connectors: The actual value of a Type N master gauge block will always vary to some degree from the desired nomi
-
nal value. The recorded measured value of the master gauge must be observed when calibrating the Pin Depth Gauge to the desired
nominal value. Although the AutoCal Module Pin Depths are not critical, this information may be helpful in the measurement of Type N
mating components. Examples are shown in Table 10-1, on the preceding page.
Table 10-2. AutoCal Module Connector Pin Depth Specifications