Filter
Top Products
Standard Calibration Setup Flow—Description
1. Pressing the Begin Cal key calls Menu C11.
2. With one exception, the flow is from left to right in the direction of
the arrow head. The exception occurs in Menu C1, for the TIME
DOMAIN choice. Here the flow direction reverses to Menu C2C
then returns to a left-to-right flow on to Menu C3 or C3D.
3. Arrowheads that point both left and right indicate that the flow
returns to the right-most menu after a choice had been made.
4. The group of menus to the left of Menu C3 and C3D are the initial
selection set and are essentially the same for all four calibration
types: Standard, Offset-Short, TRM, and LRL/LRM.
5. The group of menus that follow Menu C3 or C3D are, for the most
part, type specific. The selection of Menu C3 or C3D depends upon
the choice made in Menu C11A: COAXIAL or MICROSTRIP. For
the Standard Calibration, the WAVEGUIDE selection in Menu
C11A is not used.
37xxxE OM 4-11
FRONT PANEL OPERATION CALIBRATION KEY-GROUP