Filter
Top Products
Multiple Source Control Pre-operational Setup
The two sources receive control information from the 37xxxE VNA.
The GPIB address assigned to the external source must be identical to
the address contained in the data directed to the source by the 37xxxE
VNA. Assure source/VNA address compatibility as follows:
Step 1. Install Sources 1 and 2 on the Dedicated GPIB bus.
Step 2. Press the Utility Menu key.
Step 3.
Move cursor to GPIB ADDRESSES and press Enter,
when menu U1 (left) appears.
Step 4. When menu GP7 (left) appears, observe that the ad-
dress number is correct. If necessary, use the keypad
to enter a new address.
MULTIPLE SOURCE CONTROL MEASUREMENTS
8-30 37xxxE OM
MENU U1
SELECT UTILITY
FUNCTION OPTIONS
GPIB ADDRESSES
DISPLAY
INSTRUMENT
STATE PARAMS
GENERAL DISK
UTILITIES
CAL COMPONENT
UTILITIES
AUTOCAL UTILITIES
COLOR
CONFIGURATION
DATA ON(OFF)
DRAWING
BLANKING
FREQUENCY
INFORMATION
SET DATA/TIME
PRESS <ENTER>
TO SELECT
OR TURN ON/OFF
MENU 7
GPIB ADDRESSES
IEEE 488.2
GPIB INTERFACE
ADDRESS
6
DEDICATED
GPIB INTERFACE
EXTERNAL SOURCE 1
4
EXTERNAL SOURCE 2
5
PLOTTER
8
POWER METER
23
FREQUENCY COUNTER
7
.
-
Measurement
Enhancement
Channels
Display
Utility
Menu