Filter
Top Products
37xxxE OM A-17
ALPHABETICAL LISTING A
MENU DESCRIPTION GPIB COMMAND
AUTOCAL
ADAPTER REMOVAL
None
ISOLATION
AVERAGING
None
OMIT Select to omit the isolation step. ACOMIT
DEFAULT Select to use the Default value during the isolation step. ACDEF
AVERAGING
FACTOR
XXXX
Select for user defined averaging factor during the isolation
step.
ACIAF
PORT CONFIG
ADAPT & L=1, R=2
L=1, ADAPT&R=2
ADAPT&R=1, L=2
R=1, ADAPT & L=2
Switch between the side of the AutoCal module and
adapter which is connected to Port 1 and Port 2 (default
LEFT connected to Adapter which is then connected to
Port 1, RIGHT connected to Port 2).
ACAL1R2;
ACL1AR2;
ACAR1L2;
ACR1AL2;
ACARP?
TEST SIGNALS Calls menu CAL_SU2, which lets you enter calibrate Flat
Test Port Power or change source power(s) and attenuator
settings.
None
START AUTOCAL Calls menu CAL_SEQ, which starts the AutoCal calibration
sequencing.
None
PRESS <ENTER>
TO SELECT
OR SWITCH
Press the Enter key to select or switch. None
Menu ACAL_AR, AutoCal Adapter Removal Menu