Filter
Top Products
37xxxE OM A-35
ALPHABETICAL LISTING C
MENU DESCRIPTION GPIB COMMAND
CONFIRM
CALIBRATION
PARAMETERS
Used for SOLT method and microstrip line type. None
PORT 1 OPEN/SHORT
XXXXXXXX
Calls menu C4B, which is used to select an offset short kit
for Port 1.
None
PORT 2 OPEN/SHORT
XXXXXXXX
Calls menu C4B, which is used to select an offset short kit
for Port 2.
None
REFLECTION
PAIRING
XXXXXXXX
Calls menu C13A for a SSLT calibration or calls
menu C13B for a SSST calibration, which lets you select
the pairing (mixed or matched) for the types of reflection
devices (open/short) that you will use on Ports 1 and 2 for
calibration.
None
LOAD
IMPEDANCE
XXXXXXXX
Calls menu C6A, which lets you select an impedance type
and/or enter an impedance value.
None
THROUGH LINE
PARAMETERS
XXXXXXXX
Calls menu C20, which lets you enter throughline
parameters—including offset length and loss equation
coefficients.
None
MICROSTRIP
PARAMETERS
XXXXXXXX
Calls menu C16, which lets you change microstrip
parameters.
None
TEST SIGNALS Calls menu CAL_SU2, which lets you enter calibrate Flat
Test Port Power or change source power(s) and attenuator
settings.
None
START CAL Starts the standard calibration sequence using microstrip
standards.
BEG
PRESS <ENTER>
TO SELECT
OR CHANGE
Pressing the Enter key implements your menu selection. None
Menu C3D, Confirm Calibration Parameters