Filter
Top Products
37xxxE OM A-221
ALPHABETICAL LISTING S
MENU DESCRIPTION GPIB COMMAND
SWEEP SETUP None
START
XXX.XXXXXXXXX GHz
Enter the sweep-start frequency in GHz. The start
frequency must be lower than the stop frequency.
SRT
STOP
XXX.XXXXXXXXX GHz
Enter the sweep-stop frequency in GHz. The stop
frequency must be higher than the start frequency.
STP
SET CENTER/SPAN Calls menu SU1_CENTER, which lets you set values for
center frequency and span width.
None
XXX DATA POINTS
XXX.XXXXXXXXX GHz
STEPSIZE
Displays the number of frequency points and the spacing
between points for the start and stop frequencies
selected above. The number of points shown provides
the finest frequency resolution possible, based on your
Data Points key menu selection.
None
C.W. MODE ON (OFF)
XXX.XXXXXXXXX GHZ
Move cursor here and press Enter to enable the CW
mode. Enter CW frequency for measurements.
CWF; CWON;
CWON?; SWP;
SWP?
MARKER SWEEP Move cursor here and press Enter to set the start and
stop frequencies (menu SU5) of the CW frequency
(menu SU6) to the values of any marker.
None
DISCRETE FILL Calls the Discrete Fill menu (menu DF1). None
HOLD BUTTON
FUNCTION
Calls menu SU4, which lets you set the action of the
HOLD key.
None
TEST SIGNALS Calls menu SU2, which lets you set the source power
and the values for the attenuators in the 37xxxE. It also
provides entry into the Flat Test Port Power calibration.
None
PRESS <ENTER>
TO SELECT
OR TURN ON/OFF
Pressing the ENTER key implements your menu
selection.
None
Menu SU1, Sweep Setup 1