Filter
Top Products
37xxxE OM A-109
ALPHABETICAL LISTING G
MENU DESCRIPTION GPIB COMMAND
SWEPT POWER
GAIN COMPRESSION
None
CALIBRATE
FOR LINEARITY
(NO CAL EXISTS)
Calls menu GC_SU8A with extended menu EXT_GC_SU8A
and menu GC_SU8A_ABORT. Upon a successful power
linearity calibration, menu GC2 reappears with (CAL
EXISTS) and linearity correction ON.
None
LINEARITY ON (OFF)
CORRECTION
Toggles the linearity correction on and off. PSWC0;
PSWC1;PSWCX?
CALIBRATE
RECEIVER
(NO CAL EXISTS)
Calls menu GC_RCVR. None
S21 OPTIONS
(NOT STORED)
Calls menu GC_S21OPT. None
AUT TEST TYPES None
GAIN COMPRESSION Closes the extended menu and displays the dual channels
1 & 3, with channel 3 active. Up to this point, the system is
sweeping frequencies. Once <Test AUT> is pressed, the
power sweep mode is turned ON and the system goes into
single sweep and hold. One power sweep at the current
power freq is done and the system goes into hold with Bias
and RF ON. Pressing the Hold key will restart the sweep.
CALR
AM/PM Closes the extended menuand displays dual channel2&4,
with Channel 4 becoming active.The power sweep mode is
activated and the VNA goes into continuous sweep. The
power sweeps at the current power frequency; the marker
function is turned off, but markers remain. Channel 2
displays S21 on a Phase graph and Channel 4 displays
S21 on a Log Magnitude graph.
SPAMPMT
MULTIPLE FREQ
GAIN COMPRESSION
Calls menu GC4. None
RETURN TO SWEPT
FREQUENCY MODE
Returns program to the swept frequency operational mode. None
PREVIOUS MENU Returns to previous menu. None
PRESS <ENTER>
TO SELECT
OR TURN ON/OFF
Pressing the Enter key implements your menu selection. None
Menu GC3, Swept Power Gain Compression 2