Filter
Top Products
37xxxE OM A-41
ALPHABETICAL LISTING C
MENU DESCRIPTION GPIB COMMAND
CONFIRM
CALIBRATION
PARAMETERS
None
TRM REFLECT
OFFSET LENGTH
+XXX.XXX mmX
Enter the offset length of the TRM reflection. TOL; TOL?; ROL;
ROL?
TRM REFLECT TYPE None
GREATER THN Zo Specifies the reflection to have an impedance value greater
than the reference impedance (Z
0
)
.
This is typically an open
device.
RGZ; RXZ?
LESS THAN Zo Selects the reflection to have an impedance value less than
the reference impedance (Z
0
). This is typically a short
device.
RLZ; RXZ?
TRM MATCH
IMPEDANCE
Calls menu C6B, which lets you change the match
impedance of the coaxial line standard to other than 50 W
(default).
None
MICROSTRIP
PARAMETERS
XXXXXXX
Calls menu C16 or 16A, which lets you change microstrip
parameters.
None
TEST SIGNALS Calls menu CAL_SU2, which lets you enter calibrate Flat
Test Port Power or change source power(s) and attenuator
settings.
None
START CAL Starts the standard calibration sequence using microstrip
standards.
BEG
PRESS <ENTER>
TO SELECT
OR CHANGE
Pressing the Enter key implements your menu selection. None
Menu C3J, ConfirmCalibration Parameter 3