Filter
Top Products
Step 10. Secure the new right cover (3) from this retrofit kit to the right side
chassis of the instrument by installing the center screw (6) through
the center of the right side cover and the previously removed center
screw at the rear of the right side cover.
Step 11. Secure the slide assembly (4) to the right cover by installing the four
mounting screws (5) to the right chassis.
This completes the installation of the slide assembly.
2-9 STORAGE OR SHIPMENT The following paragraphs describe the procedure for preparing the
37xxxE for storage or shipment.
Preparation for Storage Preparing the 37xxxE for storage consists of cleaning the unit, packing
the inside with moisture-absorbing desiccant crystals, and storing the
unit in a temperature environment that is maintained between –40
and +70 degrees centigrade (–40 to 156 degrees Fahrenheit).
Preparation for Shipment To provide maximum protection against damage in transit, the 37xxxE
should be repackaged in the original shipping container. If this
container is no longer available and the 37xxxE is being returned to
Anritsu for repair, advise Anritsu Customer Service; they will send a
new shipping container free of charge. In the event neither of these
two options is possible, instructions for packaging and shipment are
given below.
Use a Suitable Container
Obtain a corrugated cardboard carton with a 275-pound test strength.
This carton should have inside dimensions of no less than six inches
larger than the instrument dimensions to allow for cushioning.
Protect the Instrument
Surround the instrument with polyethylene sheeting to protect the fin-
ish.
Cushion the Instrument
Cushion the instrument on all sides by tightly packing dunnage or
urethane foam between the carton and the instrument. Provide at
least three inches of dunnage on all sides.
Seal the Container
Seal the carton by using either shipping tape or an industrial stapler.
Address the Container
If the instrument is being returned to Anritsu for service, mark the
Anritsu address and your return address on the carton in one or more
prominent locations.
STORAGE OR SHIPMENT INSTALLATION
2-10 37xxxE OM