Filter
Top Products
CHAPTER 6. MANAGING USERS AND STATIONS 6-31
BETA DOCUMENT - PRELIMINARY & CONFIDENTIAL
button number in the Button column, and then select a feature from the
drop-down list in the
Feature column.
Two of the selections in the feature column have parameters that must be
defined (See “Secondary Directory Number parameters” on page 6-32
and “Speed Dial parameters” on page 6-31 for details).
There are two other fields in the Phone settings section:
n LCD idle message. Enter the message that you want to appear on the
LCD display when the phone is not in use. This message usually shows
the user name and extension for the phone.
n Ring volume. This slider bar adjusts the default ring volume for the
phone.
Hands free answering
The Hands free answering section contains user options for hands-free mode.
n Enable Hands-free answering. Check this box to enable hands-free
answering for a user.
n Dial tone duration before going silent. Enter the time in seconds that
the user must wait between calls (before the dial tone ends). To end a
hands-free call, the user presses the
Flash button or hangs up, but has to
wait for the phone to go off-hook again. During this time the user hears a
dial tone. This setting allows you to set the timeout to “0” so that the user
does not hear a dial tone and returns to off-hook status immediately after
disconnecting from a call.
Speed Dial parameters
If you select the Speed Dial feature in the Button settings list box (see page 6-30)
and then click the button in the Parameter column, the Speed Dial window opens.
To speed-dial an extension, click
Extension and select an extension from the