Filter
Top Products
APPENDIX A. STRATA CS CONFIGURATION SETTINGS A-15
BETA DOCUMENT - PRELIMINARY & CONFIDENTIAL
5. Set the contents of
DisableDevices
to a comma-separated list of the
device names you are disabling.
For example, to disable the third and fourth channels on the first voice
board in a system, set the contents of
DisableDevices
as follows:
DXXXB1C3,DXXXB1C4
To disable all the channels on a board, set
DisableDevices
to the board
name without any channel, for example:
DXXXB1
6. Save the changes to the registry.
Note:
If you add or remove Dialogic boards, you must update the DisableDevices
list.
Dialogic device names
Dialogic system software creates standard names for devices and channels within
devices. These names are used to open the devices to receive device handles,
which are used in all subsequent Dialogic driver functions.
Dialogic voice board device names
A Dialogic voice board device name has the form DXXXBnCn, where Bn is the
board number and
Cn is the channel number. For example, Channel 1 on Board 1
would be named DXXXB1C1. If multiple voice boards have been installed, the
board number 1 is assigned to the Dialogic voice board that was installed in the
Strata CS Server with the lowest board ID. (For information about setting
Dialogic board IDs, see Strata CS Installation & Maintenance Manual.) The
board number is then incremented by 1 for every four voice ports. The channel
number is assigned sequentially starting with 1 each time the board number
changes and incremented by 1 for each voice channel. Whenever all the devices
on one Dialogic voice board have been named, the board-numbering sequence
continues on the Dialogic voice board that was installed with the next lowest
board ID.