Filter
Top Products
CHAPTER 13. CONFIGURING INTERNET TELEPHONY SUPPORT 13-15
BETA DOCUMENT - PRELIMINARY & CONFIDENTIAL
Immediately connecting to dial tone on the remote Server
You can configure the dialing service to allow users to actually hear the remote
Server’s dial tone, so they can log in and check remote voice mail boxes, or press
411 to access the dial-by-name directory on the remote Server.
1. Create a dialing service exactly like the one described above.
2. Set
Minimum and Maximum number of digits to 0.
With these settings, Strata CS connects to the remote dial tone immediately after
the access code is entered (for example, 71), rather than waiting for digits to be
collected by the local Server and then passed to the remote Server.
Note:
Another way of accomplishing the same thing—without changing the
minimum and maximum digits—is to instruct users to press # immediately after
dialing the access code, as in 75#.
Placing phone calls through the remote Server
To place outbound calls through a remote Server over IP, you must create an
Internet-to-Phone Number dialing service.
1. Choose
File > New > Dialing Service > Internet-to-Phone Number
Service.
2. On the General tab, enter the following information about the remote
Strata CS Server:
n IP Gateway. Select the IP Gateway that will direct calls from this
dialing service to a remote Strata CS Server. See “Creating an IP