Filter
Top Products
10-4 STRATA CS ADMINISTRATOR MANUAL
BETA DOCUMENT - PRELIMINARY & CONFIDENTIAL
outbound call. Check this option to prompt for an account code
immediately after the user dials an access code (for example, 9).
Uncheck the box to prompt for account code after the user completes
dialing the phone number.
3. Check
Verify account code according to range to have the system
verify account codes by length. If an account code contains too many
digits or too few digits, the user is prompted to enter it again. Under
Minimum length and Maximum length, specify the acceptable range
for account code length. For example, if account codes in your system
can be two, three, or four digits, enter a
Minimum length of 2 and a
Maximum length of 4.
Note:
It is more efficient to set Minimum length and Maximum length
to the same number and use account codes that are all the same length.
When set up this way, the system immediately recognizes when a user
finishes entering an account code, so the user does not need to press #
at the end of the account code. When account codes are of variable
length the user must press # to end the account code or there will be a
slight pause while the system waits for more digits.
If Minimum length and Maximum length are both set to 0, account
codes are not verified by length.
4. Click
OK.
Setting a user’s account code modes
Whether or not users are prompted to enter account codes depends on the account
code modes for each individual user.
Note:
You can set default account code modes after setting the account code
modes for new users. The default modes appear for each new user you create.
See “Setting general account code options” on page 10-3.