Filter
Top Products
APPENDIX D. USING QUICKNET AND E-TEL WITH STRATA CS D-15
BETA DOCUMENT - PRELIMINARY & CONFIDENTIAL
Administrator as follows: go to the Trunks view, right-click the Internet
span, choose
Open Span, and click the Codecs tab. The codec used by
the span is displayed on that tab.
12. If the Strata CS Server uses VAD, then check
Enable VAD. You can
check whether the Strata CS Server uses VAD by using the Strata CS
Administrator as described in step 11. The VAD option is on the Codecs
tab.
13. Click the Dial Plan tab.
On the Dial plan tab you configure how the FreeRide phone responds to
each initial digit you can press on it. To set up FreeRide as a Strata CS
station, you must configure each digit to connect to the Strata CS
Server’s IP address and log in using your extension and password. In the
example above, when you pick up the FreeRide phone and dial 333, the
dial plan reads the initial digit, 3, and connects to the Destination
Address 10.11.12.7 (the Strata CS Server), then logs in using extension
208 and password 209, then dials extension 333 on the Server. All this
occurs behind the scenes; the result is that you are connected
immediately to extension 333.
14. Click
Add or Edit to configure each digit between 0 and 9, and the #
character. For each digit, do the following:
n Under Destination Address, enter the IP address of your Strata CS
Server.
n Under Prefix Add, enter your Strata CS extension and password
separated by the star character (*) as follows:
*<extension>*<password>*.
n Specify a minimum and maximum length of the dial string as shown
in the illustration above. For most digits, this will be the length of a
Strata CS extension. For 0, specify a minimum and maximum length