Filter
Top Products
CHAPTER 5. MANAGING TRUNKS AND SPANS 5-13
BETA DOCUMENT - PRELIMINARY & CONFIDENTIAL
5. In the Modify Action dialog box, select the Digit type to retrieve. You
can retrieve DID, ANI, or filler digits.
n To retrieve fixed-format data, click Exactly __ digits, and then type
the number of digits to collect.
n To retrieve variable-format data in which each piece of information
may vary in length, and filler digits are used as separators, click
Variable up to the first ___ digit, and then type the separator
character.
6. Click
OK.
7. Repeat steps 4-6 to add all the actions required to collect digits coming
in on the trunk.
8. Click
OK.
After analog digit collection has been configured correctly, make sure that the
trunk is configured to accept inbound calls and retrieve DID digits. Both these
settings appear in the Trunks view and can be configured in the Trunks dialog
box.
Adding a digital Robbed Bit T1 span ______________________
This section explains how to add a digital Robbed Bit T1 span by configuring
signalling and adding the span to Strata CS in the Trunks view.
Configuring signaling using the Robbed Bit T1 Experimenter
Before you add a Robbed Bit T1 span in the Administrator, you must run the
Strata CS Robbed Bit T1 Experimenter on the Strata CS Server computer to
configure signaling on the T1 trunk. For information about installing and using
the Experimenter, see Strata CS Installation & Maintenance Manual.
Adding the Robbed Bit T1 span in the Trunks view
After you configure signaling on the span correctly using the Robbed Bit T1
Experimenter, you can add the span in the Administrator.