Filter
Top Products
5-10 STRATA CS ADMINISTRATOR MANUAL
BETA DOCUMENT - PRELIMINARY & CONFIDENTIAL
Adding an analog trunk_________________________________
Use the following procedure to add a new analog, analog DID, or analog Centrex
trunk.
1. Choose
Trunks > New Trunk > Analog Trunk. A new Trunk dialog box
opens.
2. Enter the number and name of the trunk:
n Number. Identifies the hardware resource on the Server used for this
line. The number must correspond to the port on the Dialogic BCP
Connection Panel to which the trunk is connected.
If you have a mix of analog and digital trunks, be sure that you assign
trunk numbers that reflect how trunks will be installed in your
system. Analog trunks always use the lower-numbered trunks, so
either add the analog trunks first, or bump up the starting trunk
number for the digital span to reflect the actual line number. See
“About digital and Internet spans” on page 5-9 for information about
adding a digital span.
n Name. Descriptive name for the trunk. See “Naming trunks” on
page 5-3.
3. Choose whether the trunk is used for inbound calls, outbound calls, or
both, using the following fields:
n Accept inbound calls. Check this box if the trunk is used for
inbound calls.