Filter
Top Products
CHAPTER 5. MANAGING TRUNKS AND SPANS 5-15
BETA DOCUMENT - PRELIMINARY & CONFIDENTIAL
Note: If you are running the Administrator on the Server, click Edit to
start the Experimenter. Otherwise, you must run the Experimenter on the
Strata CS Server.
4. On the Trunks tab, set the default values for the 24 trunks that will be
created in this span. You can then change these values for each trunk
individually. See “Entering trunk defaults for a span” below.
5. Click
OK to add the span to your configuration.
Using a signaling template
The Robbed Bit T1 Experimenter includes templates that contain Robbed Bit T1
signaling definitions that will be valid in many cases:
n E&MSignaling. Use if your Robbed Bit T1 line supports E&M
signaling.
n Local1. Use for a local Robbed Bit T1 line.
n Longdistance. Use for a long-distance Robbed Bit T1 line.
To apply a template to a span, click
Apply Template on the Signaling tab. Select
the template to apply, click
Open, and then click OK.
Note: If you have installed the Robbed Bit T1 Experimenter to a directory other
than the
Strata CS Administrator’s directory, you must look for the template there.