Filter
Top Products
APPENDIX D. USING QUICKNET AND E-TEL WITH STRATA CS D-9
BETA DOCUMENT - PRELIMINARY & CONFIDENTIAL
Eliminating access code conflicts
If there are any Gateways with the same access codes as Strata CS dialing
services, you must change the access codes in Quicknet. For example, if there is
a Quicknet Gateway with access code 9, and 9 is the access code you dial to get
an outside line in Strata CS, you must change the Quicknet Gateway’s access code
to a number other than 9.
Look in the Telephone Gateways list under the Number column. If there is a
conflict, right-click the Gateway and select
Properties. Change the access
code—the field will be called either Number or Extension, depending on the type
of Gateway—and then click
OK.
Transferring and handling calls with a Quicknet phone
You must make a configuration change to Quicknet in order to transfer and handle
calls using Strata CS's telephone commands. After the configuration change is
made, you can transfer and handle Strata CS calls just as you would from a normal
phone.
The configuration change involves the Flash command. When using Strata CS
from a remote phone—IP or otherwise—you must press ** instead of Flash. In
order to use ** from Quicknet, you must first do the following:
1. From the
Internet Switchboard menu, choose Show Advanced
Features,
if the advanced features are not already showing.
2. From the Internet Switchboard menu, choose
Properties. The Internet
Switchboard Properties dialog box opens.
3. Click the Calling tab.