Filter
Top Products
5-18 STRATA CS ADMINISTRATOR MANUAL
BETA DOCUMENT - PRELIMINARY & CONFIDENTIAL
trunk numbers, so if you have not added them yet, leave room for
them in your numbering of the span.
3. On the Tuning tab, optimize your ISDN settings as needed. See
“Optimizing your ISDN settings” on page 5-19.
4. On the Trunks tab, set the default values for the 24 trunks that will be
created in this span. You can then change these values for each trunk
individually. See “Entering trunk defaults for a span” on page 5-16.
5. Click
OK to add the span to your configuration.
Note:
ANI/DNIS is automatically retrieved by Strata CS for these types of digital
trunks.
Adding a digital ISDN BRI span __________________________
Use the following procedure to add a new ISDN Basic Rate Interface (BRI) span.
To add Primary Rate Interface (PRI) spans, see “Adding a digital ISDN or CAS
span” on page 5-17.
1. Choose
Trunks > New Trunk > ISDN BRI Span. A new ISDN BRI Span
dialog box opens
2. On the General tab, specify the following information for the span:
n BRI board number. The sequence number of the span.