Filter
Top Products
8-18 STRATA CS ADMINISTRATOR MANUAL
BETA DOCUMENT - PRELIMINARY & CONFIDENTIAL
n Minimum, Maximum number of digits. When a user dials a
Centrex/PBX extension, Strata CS waits to collect all of the digits up
to the minimum number of digits you specify here, and does not dial
them until one of the following occurs:
n A time-out elapses (see “Setting dialing timeouts” on page 4-13)
n The user presses # to signify that all digits have been entered
n The maximum number of digits (that you specify below) have
been entered
If every Centrex/PBX extension that users can dial is the same length,
you can expedite dialing by entering that information here. For
example, if all Centrex/PBX extensions are 3 digits long, set both
values to 3.
n IP Gateway. Select the IP Gateway that will direct calls from this
dialing service to a remote Strata CS Server. To create a new IP
Gateway, click the IP Gateway button. See “Creating an IP Gateway”
on page 13-9.
n Place Centrex/PBX calls on remote Server using. Choose how
calls from this dialing service will connect to the remote Server:
n Remote Server’s Centrex/PBX service access code. The
remote Server places a call using the Centrex/PBX Extension
dialing service whose access code you enter here. This option lets
users dial Centrex/PBX extensions external to the remote Server,
for example, to connect to a legacy PBX on the remote Server, or
dial a Centrex extension.
n Remote Server’s internal dial tone. The call is connected to the
remote Server’s internal dial tone, as if the user was dialing from
a station on that Server. This option lets users dial internal Strata
CS extensions on the remote Server, or log in to an account on
that Server.
3.
Trunks tab. Click the Trunks tab (see “Trunks tab” on page 8-18) and
choose the trunks that this dialing service will use to place calls.
4.
Codecs tab. Click the Codecs tab (see “Codecs tab” on page 8-21) and
choose whether to default to or override the codecs specified for the
Internet span used by the service.
5. Click
OK from any tab to add the dialing service.
Trunks tab
The Trunks tab is used by all dialing service types except routing services (see
page 8-29). This tab specifies the trunks to which calls will be routed, and the
order in which those trunks will be allocated.